- The functions and advantages of PVC floor glue
- Misunderstandings in the use of floor leather
- Tips for color matching of home floors
- Sing the main theme of scientific and technological innovation
- A New Showroom for Product Innovation and Global Development
contact person:Huangang Team
cell phone:+86-0315-6440926
Telephone:+86-0315-6440926
email:hg@hgpvc.com.cn
address:Shagoutun, Liangjiadian Town, Yutian County, Hebei Province, China (Factory), No. 1118, Xingang East Road, 1088 Haizhu District, Guangzhou City, Guangdong Province, China (Guangzhou Office - Zhongzhou Trading Center)
Experts teach you the construction procedures and methods for laying coil floors
Floor leather (also known as coil flooring) is one of the indispensable floor materials for modern living room decoration. It is not only beautiful, but also has good practical effect. It also has the characteristics of sound insulation, moisture insulation, wear resistance, corrosion resistance, etc. It can be used not only for living room floors, but also for kitchen walls, bathroom floors, and walls to replace ceramic tiles.
The construction procedure and method of paving floor leather are: first measure the structural size of the room, the measurement should be accurate, and then cut the floor leather according to the size. Note that the width of the cutting should be slightly larger than the required width, so as to facilitate the overlap and trimming when paving.
The finished floor leather should be left at room temperature of not less than 15 degrees Celsius for about 24 hours, so that the curled part of the floor leather can be fully extended and ready for final paving.
A special adhesive is used for paving floor leather. Before paving, the indoor floor should be treated first, the first is to clean it to remove oil stains or dust and sand. The second is to level, the raised areas should be shoveled and ground flat, and the depression can be made into a paste with 107 glue and cement in a weight ratio of 1:2, leveled with a spatula, and then leveled with sandpaper after drying. After the ground is flat, clean and dry, it can be glued and pasted.
Glue is the last step before paving, and the tool should be a toothed scraper board. When gluing, glue should be applied on the ground according to the size of the floor leather, and pasted one by one, in this order. There should be a width of 10 cm at the seams of the leather without gluing, so that the seams can be finally treated.
The glue coated on the local surface can be laid after feeling sticky by hand. Pay attention to aligning the edge line when pasting. When using it, use a long handle brush to drive air out and compact it. Floor seams are generally spliced by overlapping cutting, and the overlapping width is about five centimeters. Align the center of the overlap with a long steel plate ruler, cut with a cutter along the ruler, and then remove the cut edge strips (note that there should be two edge strips, don't forget to take out the following one), brush an appropriate amount of glue on the seam with a paint brush, and then use a pressure roller to close and compact the seam. Wipe the residual glue extruded at the seam to avoid affecting the appearance. Then apply a thin layer of seam liquid along the seam.
Finally, you should also check whether there are bubbles and whether they are flat. If there are bubbles, you can insert a syringe to suck out air and then compact them. Finally, use washing powder to remove the remaining glue marks on the floor leather. If it cannot be removed, you can wipe it with alcohol. This completes the whole process.
- Previous:No.
- Next:The importance of PVC floor leather industry brands
-
2026-06-05Tips for color matching of home floors
-
2026-06-05Customer visit
-
2026-06-05Huangang Company Successful Share Reform
